Purelink is proud to announce the new single CATx (HDBaseT) extension system called PM-CT102 and CR102, a part of new PM series extender. PM-CT102 and CR102 are a transmitter and receiver set for long distance transmission of video, audio, and control signal with POE (CR102 doesn't support POE). PM series CATx (HDBaseT) extension system is designed to transmit video (DVI, HDMI and VGA), audio (Embedded or analog stereo audio), control (RS232/422 and IR), and power over a single CATx cable for long distance up to 330ft (CR102 doesn't support POE). This CATx connection enables to minimize electrical noise and EMI free that is ideal for long distance extension of high definition HDMI/DVI video signal, HDMI embedded audio or 3.5mm stereo analog audio, and control signal with POE (CR102 doesn't support POE).
|CATx cabling between transmitter and Receiver|
|Connector||Female RJ-45 per unit for connecting the Tx and Rx|
|Operating distance||up to 330ft (100m) Using CAT 5e/6/7 UTP or STP cable (24AWG or above)|
NOTE: Operating distance is approximate. This is a typical distance. The maximum distance may be greater than these typical numbers depending on factors such as CATx type, bandwidth, connector splicing, losss, bend radius and environmental factors.
|Termination Standards||TIA/EIA T568A or T568B|
|Maximum Channel Data Rate||3.40 Gbps per color|
|Pixel clock||165 MHzz|
|Supported resolution||Up to 1920 x 1200 / 1080p @ 60Hz / 4K x 2K (Optional)|
|Formats||RGB, YCbCr & xvYCC digital|
|Image Scaler||Sigma Design GF9452A|
|Connector||3.5mm Mini Jack Stereo Audio|
|Gain||Unbalanced output: 0 dB, Balanced output +5 dB|
|Frequency response||20Hz, ±0.05dB|
|Impedance||>10K ohms( input) 50ohms (unbalanced output) 100 ohms (balanced output)|
|Maximum level||+6 dBV (Unbalanced, input), > ±16 dBu (balanced output)|
|Video connector - Transmitter & Receiver|
|Control - external device (Pass-thru, bidirectional)|
|Serial control port|
|Transmitter||3 Female phoenix connector, (Tx, Ground, Rx)|
|Receiver||3 Female phoenix connector, (Tx, Ground, Rx)|
|Baud rates||Support up to 115200|
|IR control port||4 Female phoenix connector (VCC, IN, OUT, GRN)|
|Power supply||Ext. adapter - Input: 100-240 VAC, 50-60 Hz, Output: 12VDC, 4.1A, 10 watts(max)|
NOTE: Both transmitter and receiver extender don't need to be powered because of the POE feature.
|Mounting||Mounting ears for ceiling and in-wall installation|
|Dimension||6.3' (w) x 5.3' (d) x 1.7' (h)|
|Weight||1.77 lbs per receiver, 1.43 lbs per transmitter|
NOTE: All nominal levels are at ± 9%
NOTE: Specifications are subject to change with or without notice.