Purelink is proud to announce the new single CATx (HDBaseT) extension system called PM-CT102 and PM-CR102, a part of new PM series extender. PM-CT102 and PM-CR102 are a transmitter and receiver set for long distance transmission of video, audio, and control signal with POE (PM-CR102 doesn't support POE). PM series CATx (HDBaseT) extension system is designed to transmit video (DVI, HDMI and VGA), audio (Embedded or analog stereo audio), control (RS232/422 and IR), and power over a single CATx cable for long distance up to 330ft (PM-CR102 doesn't support POE). This CATx connection enables to minimize electrical noise and EMI free that is ideal for long distance extension of high definition HDMI/DVI video signal, HDMI embedded audio or 3.5mm stereo analog audio, and control signal with POE (PM-CR102 doesn't support POE).
|CATx cabling between transmitter and Receiver|
|Connector||Female RJ-45 per unit for connecting the Tx and Rx|
|Operating distance||up to 330ft (100m) Using CAT 5e/6/7 UTP or STP cable (24AWG or above)|
NOTE: Operating distance is approximate. This is a typical distance. The maximum distance may be greater than these typical numbers depending on factors such as CATx type, bandwidth, connector splicing, losss, bend radius and environmental factors.
|Termination Standards||TIA/EIA T568A or T568B|
|Maximum Channel Data Rate||3.40 Gbps per color|
|Pixel clock||165 MHzz|
|Supported resolution||Up to 1920 x 1200 / 1080p @ 60Hz / 4K x 2K (Optional)|
|Formats||RGB, YCbCr & xvYCC digital|
|Image Scaler||Sigma Design GF9452A|
|Connector||3.5mm Mini Jack Stereo Audio|
|Gain||Unbalanced output: 0 dB, Balanced output +5 dB|
|Frequency response||20Hz, ±0.05dB|
|Impedance||>10K ohms( input) 50ohms (unbalanced output) 100 ohms (balanced output)|
|Maximum level||+6 dBV (Unbalanced, input), > ±16 dBu (balanced output)|
|Video connector - Transmitter & Receiver|
|Control - external device (Pass-thru, bidirectional)|
|Serial control port|
|Transmitter||3 Female phoenix connector, (Tx, Ground, Rx)|
|Receiver||3 Female phoenix connector, (Tx, Ground, Rx)|
|Baud rates||Support up to 115200|
|IR control port||4 Female phoenix connector (VCC, IN, OUT, GRN)|
|Power supply||Ext. adapter - Input: 100-240 VAC, 50-60 Hz, Output: 12VDC, 4.1A, 10 watts(max)|
NOTE: Both transmitter and receiver extender don't need to be powered because of the POE feature.
|Mounting||Mounting ears for ceiling and in-wall installation|
|Dimension||6.3' (w) x 5.3' (d) x 1.7' (h)|
|Weight||1.77 lbs per receiver, 1.43 lbs per transmitter|
NOTE: All nominal levels are at ± 9%
NOTE: Specifications are subject to change with or without notice.